Sim2 HT5000 Bedienungsanleitung

SIM2 MultimediaSIM2 HT5000RS-232C and TCP/IP Control SpecificationsRev. 1.4 (December 28, 2007)

where:• Byte 7 (labeled SS in the table above) contains Projector Status:OK 00Power Supply Overtemperature 10Power Supply Failure 20If the unit is On,

• 1 bytes (byte 0) that initiates the packet (1E)• 17 bytes (bytes 1-17) that duplicate the sent command (apart from 2 of them — the CRC)• 3 Error byt

• 17 bytes (bytes 1-17) that duplicate the sent command (apart from 2 of them — the CRC)• 3 Error bytes (bytes 18-20) that signal errors in the proces

3 ExamplesSend the simulated ‘SWITCH ON FROM STANDBY’ Remote Control keycodeRemote Control allows Switching on from Standby via the key ‘0’.Send the c

SIM2 Multimedia S.p.A.Viale Lino Zanussi, 11 — 33170 Pordenone — ItalyTel. +39.0434383281 — Fax [email protected] USA Inc.101

ContentsContents 21 Introduction 31.1 Setting up the RS-232C Serial connection . . . . . . . . . . . . . . . . . . . . . . . . . . . 31.2 Setting up t

1 IntroductionThis document describes how to interface the SIM2 HT5000 projector with a Home Theater control system(or a PC) over a direct serial conn

1.2 Setting up the TCP/IP connectionThe control system (or the PC) can establish a TCP/IP connection to the SIM2 HT5000 projector. Thebasic steps requ

2 CommandsIn this section, serial commands (and respective responses) are listed. Commands (and responses) are seriesof bytes (numbers holding values

F1 BE EF 02 06 00 94 E6 5D 01 00 00 00 00F2 BE EF 02 06 00 76 E7 5F 01 00 00 00 00Info BE EF 02 06 00 A7 E6 5E 01 00 00 00 00Auto BE EF 02 06 00 79 E2

ContrastAction Command ResponseIncrement BE EF 1A 0C 00 9D 5E 01 00 02 00 00 00 00 00 00 00 00 00 OK 20 XX 00Decrement BE EF 1A 0C 00 58 0F 01 00 03 0

Color Management: PrimariesAction Command ResponseSet Native BE EF 1A 0C 00 68 FE 41 00 00 00 00 00 00 00 00 00 00 00 OK 20 XX 00Set HDTV BE EF 1A 0C

XX is the hex representation of the value of Gamma.Example: if the returned value is XX = 04 then Gamma is set to EN5.Lamp PowerAction Command Respons