Sim2 HTL40 Bedienungsanleitung PDF herunterladen (Seite 3)

SIM2 HTL40 LINK

RS-232C CONTROL SPECIFICATIONS

1. Introduction

This document describes the communication and data formats used to control SIM2 HTL40 LINK via RS-

232C port.

2. Connection

Switch off your Personal Computer and HTL40 LINK before connecting RS 232C cable.

Use a standard serial cable with 9 pin female to the Personal Computer and 9 pin male to the HTL40 LINK:

pin 2 connects to pin2, pin 3 to pin 3 and pin 5 to pin 5.

SIM2 HTL40 LINK RS-232C Port is described as follows.

SIM 2 HTL40 LINK RS-232C Control Port:

Pin No Signal Definition

1 N/A Not used

2 TD Transmit data

3 RD Receive data

4 N/A Not used

5 GND Ground

6 N/A Not used

7 N/A Not used

8 N/A Not used

D-SUB 9-pin

(female)

9 N/A Not used

Switch on the Personal Computer and, after start up, switch on the HTL40 LINK.

Load a suitable communication software onto your Personal Computer, and set the Serial Port Parameters as

shown below.

Communication Parameters:

Parameter Value

Transfer Rate 19200 bps

Data Bits 8

Parity Bit None

Stop Bit 1

Flow Control None

Set Send Mode and Read Mode to HEX.

1 2 3 4 5 6 7 8 ... 12 13

Keine Kommentare

Sim2 HTL40 Bedienungsanleitung Seite 3